العربية
The semi-automatic round bottle labeling machine belongs to the semi-automatic labeling machine series. It is a labeling machine suitable for round bottle labeling of PET bottles, plastic bottles, glass bottles, metal bottles, etc. It has a beautiful and elegant design, uses aluminum alloy brackets and powerful functions. Of the operating system, we will introduce in detail the specific operation method of the semi-automatic round bottle labeling machine.
1. Install the sticker label
Loosen the seven-shaped handle on the material tray to remove one of the material trays, put the label roll on, and then lock the material tray (be careful not to clamp too tightly, it is better to drag the label by hand).
2. Around the label
Follow the circumnavigation diagram drawn above to circumvent the label correctly on the machine.
3. Debugging
In the inching state, observe the change of the electric eye. When the gap between the label and the label is out, the red light of the electric eye is on (indicating the output signal). If the status of the electric eye is abnormal, please refer to the chapter on adjusting the electric eye to adjust the electric eye.
4. Trial run:
In the state of automatic operation, step on the foot switch once to observe the state of the label at the position of the label stripping board.
5. Adjust the position of the label
5.1. Observe the position of the peeling label, and use the inching method to peel the label out of 0~2mm. (Excessive labeling will cause the product to stick to the next label, and too short will cause the product to fail to stick a sticker. Label)
5.2. Under the condition of adjusting the length of the label to be appropriate, then move the detection slot of the sensor to the gap between the label and the label by moving the position of the sensor. Then, switch to the automatic state, step on the foot switch, and automatically send the label once again to observe whether the length of the label position is appropriate, and make appropriate adjustments. The length of the label can be achieved by moving the electric eye holder up and down, moving up to detect the label in advance, and the label peeling length becomes shorter. Move down to postpone the detection of the label, and the label peeling length becomes longer.
5.3 In the adjustment of the double label, pay special attention to the position of the label sensor. If the first extension of the stripping plate is the positive label, then the sensor should be detected on the positive label. If the first extension of the stripping plate is the back label, then Then click Jog 2 to adjust the distance between the two labels.
5.4. Trial labeling
Place the round bottle on the labeling station, observe the position of the label on the bottle, adjust the position of the label attached to the workpiece by moving the positioning rod on the left (when choosing a model with a coding machine, try Adjust the coding position after pasting)
